BIOMATERIAL TOXICOLOGY |
|
Biocompatible materials are intended to interface with biological systems to evaluate, treat, augment or replace any tissue, organ or function of the body
|
BIOMECHANICS |
|
Biomechanics is the research and analysis of the mechanics of living organisms.
|
CANCER - GENERAL |
|
Cancer is a class of diseases or disorders characterized by uncontrolled division of cells and the ability of these cells to invade other tissues, either by direct growth into adjacent tissue through invasion or by implantation into distant sites by metastasis. This unregulated growth is caused by damage to DNA, resulting in mutations to genes that encode for proteins controlling cell division. Many mutation events may be required to transform a normal cell into a malignant cell. These mutations can be caused by chemicals or physical agents called carcinogens, by close exposure to radioactive materials, or by certain viruses that can insert their DNA into the human genome. Mutations occur spontaneously, or are passed down generations as a result of germ line mutations.
|
CANCER - KIDNEY |
|
Renal cell carcinoma, also known by the eponym Grawitz tumor, is the most common form of kidney cancer arising from the renal tubule. It is the most common type of kidney cancer in adults. Initial therapy is with surgery. It is notoriously resistant to radiation therapy and chemotherapy, although some cases respond to immunotherapy.
|
CANCER - LUNG |
|
Lung cancer is a cancer of the lungs characterised by the presence of malignant tumours. Most commonly it is bronchogenic carcinoma (about 90%). Lung cancer is one of the most lethal of cancers worldwide, causing up to 3 million deaths annually. Only one in ten patients diagnosed with this disease will survive the next five years. Although lung cancer was previously an illness that affected predominately men, the lung cancer rate for women has been increasing in the last few decades, which has been attributed to the rising ratio of female to male smokers.
|
CARBON MONOXIDE EMISSIONS |
|
Carbon monoxide, chemical formula CO, is a colorless, odorless, tasteless, flammable and highly toxic gas. It is a major product of the incomplete combustion of carbon and carbon-containing compounds. It is less dense than air under ordinary conditions, however it accumulates on the ground, meaning that if poisoning causes loss of consciousness the amount of carbon monoxide inhaled increases and so fatality is radically increased. It is very slightly soluble in water and burns in air with a characteristic blue flame, producing carbon dioxide; it is a component of producer gas and water gas, which are widely used artificial fuels. It is a reducing agent, removing oxygen from many compounds and is used in the reduction of metals, e.g., iron , from their ores. At high pressures and elevated temperatures it reacts with hydrogen in the presence of a catalyst to form methanol. Carbon monoxide is formed by combustion of carbon in oxygen at high temperatures when there is an excess of carbon. It is also formed with a byproduct oxygen by decomposition of carbon dioxide at very high temperatures (above 2,000 °C). It is present in the exhaust of internal-combustion engines, often the exhaust of automobiles, and is generated in coal stoves, furnaces, and gas appliances that do not get enough air. This may be due to insufficient ventilation or other reasons.
|
CHEMISTRY |
|
Chemistry (derived from alchemy) is the science of matter at or near the atomic scale. In this pursuit chemistry deals with the properties of such matter, the tranformations of matter and the interactions of matter with other matter and with energy.
|
COMBUSTION |
|
Combustion or burning is a chemical process, an exothermic reaction between a substance (the fuel) and a gas (the oxidizer), usually O2, to release heat. In a complete combustion reaction, a compound reacts with an oxidizing element, and the products are compounds of each element in the fuel with the oxidizing element. For example:
CH4 + 2 O2 → CO2 + 2 2O + heat
CH2S + 6 F2 → CF4 + 2 HF + SF6 + heat
|
CORROSION EVALUATIONS |
|
Corrosion is deterioration of intrinsic properties in a material due to reactions with its environment. Weakening of steel due to oxidation of the iron atoms is a well-known example of electrochemical corrosion. This type of damage usually affects metallic materials, and typically produces oxide(s) and/or salt(s) of the original metal. Corrosion also includes the dissolution of ceramic materials and can refer to discoloration and weakening of polymers by the sun's ultraviolet light.
|
CRYOGENICS |
|
Cryogenics is a branch of physics (or engineering) that studies the production of very low temperatures (below −150°C, −238°F or 123K) and the behavior of materials at those temperatures. Cryonics is the nascent technology of cryopreserving humans and animals with the intention of future revival. Unlike cryogenics and cryobiology, cryonics is not an established science and is viewed with skepticism by most scientists and doctors today (although there are many scientists involved in cryonics[1]). As a technology, cryonics seeks to apply the results of many sciences, including cryobiology, cryogenics, rheology, emergency medicine, etc.
|
DEEP VEIN THROMBOSIS |
|
Deep Vein Thrombosis is a condition resulting from the formation of a blood clot thrombus inside a deep vein, commonly located in the calf or thigh. DVT occurs when the blood clot either partially or completely blocks the flow of blood in the vein.
|
ENDOCRINOLOGY |
|
Endocrinology is a branch of medicine dealing with disorders of the endocrine system and its specific secretions called hormones. Hormones are molecules that act as signals from one type of cells to another. Most hormones reach their targets via the blood. Although every organ system secretes and responds to hormones (including the brain, lungs, heart, intestine, skin, and the kidney), the clinical specialty of endocrinology focuses primarily on the endocrine organs, meaning the organs whose primary function is hormone secretion. These organs include the pituitary, thyroid, adrenals, ovaries and testes, and pancreas.
|
ENGINEERING - MECHANICAL |
|
Mechanical engineering is a very broad field of engineering that involves the application of physical principles for analysis, design, manufacturing, and maintenance of mechanical systems. The system can be as simple as the design of a chair for comfort or as complex as the operations of a turbocharged engine for speed. It can be as small as the manufacturing of a nano-sized gear or as large as the structure of a supertanker used to carry oil around the world.
|
HYDROLOGY |
|
Hydrology (from Greek: Yδρoλoγια, Yδωρ+Λoγos, Hydrologia, the "study of water") is the study of the movement, distribution, and quality of water throughout the Earth, and thus addresses both the hydrologic cycle and water resources. A practitioner of hydrology is a hydrologist, working within the fields of either earth or environmental science, or civil and environmental engineering.
|
LASIK |
|
LASIK, an acronym for Laser-assisted In Situ Keratomileusis, is a form of refractive laser eye surgery procedure performed by ophthalmologists intended for correcting vision. The procedure is usually a preferred alternative to photorefractive keratectomy, PRK, as it requires less time for full recovery, and the patient experiences less pain overall.
|
MICROWAVE HEATING |
|
A microwave oven, or microwave, is a kitchen appliance employing microwave radiation primarily to cook or heat food. Microwave ovens have revolutionized cooking since their use became widespread in the 1970s.
|
MOLD |
|
Molds are ubiquitous in nature, and mold spores are a common component of household dust. The term toxic mold is sometimes used to refer to mold-related indoor air quality problems.
|
ONCOLOGY |
|
Oncology - The branch of medicine that deals with cancer and tumors, including study of their development, diagnosis, treatment, and prevention.
|
PAINT |
|
Paint is the general term for a family of products used to protect and add color to an object or surface by covering it with a pigmented coating. As a verb, painting is the application of paint. One who paints is called a painter.
|
PATHOLOGY |
|
Pathology (from Greek pathos, feeling, pain, suffering; and logos, study of; see also -ology) is the study of the processes underlying disease and other forms of illness, harmful abnormality, or dysfunction. Within biology, it means specifically the study of the structural and functional changes in cells, tissues and organs that underlie disease. Another name for pathology is laboratory medicine.
|
PHARMACOLOGY |
|
Pharmacology (in Greek: pharmacon meaning drug, and logos meaning science) is the study of how chemical substances interact with living systems. If substances have medicinal properties, they are considered pharmaceuticals.
|
PLASTICS |
|
Plastic covers a range of synthetic or semisynthetic polymerization products. They are composed of organic condensation or addition polymers and may contain other substances to improve performance or economics. There are few natural polymers generally considered to be "plastics". Plastics can be formed into objects or films or fibers. Their name is derived from the fact that many are malleable, having the property of plasticity. Plastics are designed with immense variation in properties such as heat tolerance, hardness, resiliency and many others. Combined with this adaptability, the general uniformity of composition and light weight of plastics ensures their use in almost all industrial segments.
|
POLYMERS |
|
Polymer is a generic term used to describe a very long molecule consisting of structural units and repeating units connected by covalent chemical bonds. The term is derived from the Greek words: polys meaning many, and meros meaning parts [1]. The key feature that distinguishes polymers from other molecules is the repetition of many identical, similar, or complementary molecular subunits in these chains. These subunits, the monomers, are small molecules of low to moderate molecular weight, and are linked to each other during a chemical reaction called polymerization.
|
PSYCHIATRY |
|
Psychiatry is the branch of medicine that studies, diagnoses, and treats mental illness and behavioral disorders. While all physicians will encounter patients with mental illnesses and any of them may treat it, psychiatrists specialize in these areas. They are more extensively trained in the differential diagnosis (the distinguishing of various forms) and treatment of mental illness. Given the advantage of the preliminary medical training as well as further specialist training, psychiatry when practised properly offers a truly holistic approach to patient care. Many other professionals also provide mental health care, such as psychologists, nurse practitioners, counselors, physician assistants, and social workers. In general only doctors, nurse practitioners, or physician assistants may prescribe mental health medication in the United States[1]. In some countries, mental health medication may only be prescribed by medical doctors.
|
RADIOLOGY |
|
Radiology is the medical specialty that utilizes and interprets imaging technologies to diagnose disease. Traditionally it was the branch of medical science dealing with the medical use of X-rays emitted by X-ray machines or other such radiation devices for the purpose of obtaining visual information as part of medical imaging. Radiologists now also use all other imaging technologies (such as ultrasound, computed tomography (CT) and magnetic resonance imaging) to diagnose or treat disease. Interventional radiology is the performance of (usually minimally invasive) medical procedures with the help of medical imaging.
|
TOXICOLOGY |
|
Toxicology is the study of the adverse effects of chemical, physical or biological agents on living organisms and the ecosystem, including the prevention and betterment of such adverse effects.
|
TOXICOLOGY |
|
Toxicology is the study of the adverse effects of chemical, physical or biological agents on living organisms and the ecosystem, including the prevention and betterment of such adverse effects.
|
|
